Post by LunaticFringe99 on Aug 28, 2017 15:36:37 GMT -5
This is a rough prototype. I was brainstorming ideas on how I could create these, and I came up with 3 ideas.
1 - Paper Towel Tubes
2- Those foam tubes that used to be on the middle section of the handlebars of bicycles.
3- PVC tubes/pipes.
I used the cardboard tube since it was easy to cut, and so I could also work with it without messing it up. I do feel that they are a bit too big, but that can be fixed in the long run. I plan to go to the hardware store in a few days to look at the PVC types. Anyways, you all can feel free to give me feedback and ideas, since this might take a bit of time. Anything is appreciated.
Are you planning on keeping the paper towel roll? I don't know how structurally sound that will be.
I doubt I will, I was thinking about using something that would require dremel work:
I can't think of anything that would work other than PVC. Unless you wanted to 3D print the posts. Then you wouldn't need to use a Dremel on it if you know how design them, but I don't know how cost effective that would be.