|
|
Post by Jim Cornette’s Wendy’s Order🍔 on Apr 6, 2018 1:37:26 GMT -5
Hey guys, so I'd really like to fix the arms on the la resistance and reign/angle set from Adrenaline series 13. Is there any way to do this? I was a very young kid back then so I never tried splitting torsos like you can do with mattels figures, was just too young then.
Now that I've started rebuilding my ruthless aggression collection, I'd like to fix these 4 figures up, just not sure if it's possible. Anyone have some suggestions?
|
|
|
|
Post by Rated [R] NinJa on Apr 6, 2018 2:01:38 GMT -5
Angle and La Resistance will require torso splits to change the arms. As for Luther Reigns, he was a pretty basic figure so a head swap on a figure like CSTT2 Stone Cold, CS4 Hillybilly Jim, ECW3 Snitsky (some may require lower leg swaps too) will be the easiest route if you don’t want to split the torso. I’ve never split a Mattel basic torso myself but it seems to require the same method as you would use for an RA torso. There may be a tutorial in the Customs Support Board.
|
|
|
|
Post by revolution on Apr 6, 2018 2:48:40 GMT -5
Jakks torsos are usually really easy to split. just involves putting them in boiling water for a few minutes and squeezing the torso open. I use pliars. in my experience I sometimes can do it perfectly and other times leave stress marks. it's a risk
|
|
|
|
Post by "The Visionary" Eldniw on Apr 6, 2018 7:08:40 GMT -5
CHINESE NEW YEAR!!!!
|
|
|
|
Post by Dylan ❤️s Wrestling on Apr 14, 2018 7:39:36 GMT -5
Their arms should be able to pop off below the shoulder.
I saw a pic online of someone who did it to a Cody but can’t find it now.
|
|
![Rated [R] NinJa Avatar](http://storage.proboards.com/530008/avatar/IDIYNeRTVZulhCPXFiqx.png)
