Post by Smash Ventura on Sept 28, 2008 21:43:59 GMT -5
lol ardillita, you had me worried with the "Your arena is a big piece of..."...lol i would be glad to share with you my arenas measurements...
first off, the floor is the extra thick poster board(i think about a inch thick)...all the walls are normal poster board...
the concrete floor is a couple sheets of paper i found at my arts and crafts store that looked like concrete to me the matting around my RSR is the same foamy sheets that everyone is using and can also be found at allot of places..
the walls(since i was unable to find black poster board) are covered in black duct tape so that the crowd and the other print outs stand out better and have the arena feel...
the area where pipers pit is,is for various interview sets...i can switch pipers pit out with the brother love set,or the prime time wrestling set...those sets are made separately so i can swap them out when i need to...
now on to the measurements...
the floor is about 59 1/2 inches by 40 inches...
the back wall is 59 1/2 inches long and 21 inches high...
both Left and right walls are 40 inches long by 21 inches high...
now in my case i have that little pieces of wall in each corner to give that curved look like a doam arena and that is about 9 inches long and 21 inches high
not sure if this helps but... i like to have floor room (for eventual figures and chairs that will be in the floor level seating) and of course if the action spills over the rails and into the fans...
th space from ring apron to rig guardrail is 9 inches... the space from gard rail to wall is 10 inches..giveing ya space for figure fans if you want and brawls in the fan area...
i hope this helps you and anyone else who was interested in how i went about setting my arena up..
thanks so much for the praise everybody...when i get time i will do a roster pic in my arena like wars did in his...wars,love that pic bro;)
first off, the floor is the extra thick poster board(i think about a inch thick)...all the walls are normal poster board...
the concrete floor is a couple sheets of paper i found at my arts and crafts store that looked like concrete to me the matting around my RSR is the same foamy sheets that everyone is using and can also be found at allot of places..
the walls(since i was unable to find black poster board) are covered in black duct tape so that the crowd and the other print outs stand out better and have the arena feel...
the area where pipers pit is,is for various interview sets...i can switch pipers pit out with the brother love set,or the prime time wrestling set...those sets are made separately so i can swap them out when i need to...
now on to the measurements...
the floor is about 59 1/2 inches by 40 inches...
the back wall is 59 1/2 inches long and 21 inches high...
both Left and right walls are 40 inches long by 21 inches high...
now in my case i have that little pieces of wall in each corner to give that curved look like a doam arena and that is about 9 inches long and 21 inches high
not sure if this helps but... i like to have floor room (for eventual figures and chairs that will be in the floor level seating) and of course if the action spills over the rails and into the fans...
th space from ring apron to rig guardrail is 9 inches... the space from gard rail to wall is 10 inches..giveing ya space for figure fans if you want and brawls in the fan area...
i hope this helps you and anyone else who was interested in how i went about setting my arena up..
thanks so much for the praise everybody...when i get time i will do a roster pic in my arena like wars did in his...wars,love that pic bro;)