Cracking Open WWE Elite Bodies Tutorial

Do you have a water phobia or something?

glad it helps. Remember just to just take your time

you sure are, but it looks like you can still use some work on mixing better matching skin tones. Still good work so far.

Thanks to helsinkihellraiser and Apocalypse. I just took their ideas did a little tinkering and just wanted to share it with everyone else. I use this way to avoid the stress and cracks that occur when opening an elite figure. Hope it helps


Elite Perfect, box cutter, flat head screwdriver, container with water

Boil Water for 5 mins in microwave

Dip head and neck only in the water for about 1 minute. than remove head and put water back in microwave for 4 mins.

As the water is boiling take a box cutter and slice at the seam of the neck. Dont cut the peg just the seam. You should hear a slight crack. this is done so the neck wont get stress marks or break.


Once the water finishes boiling take it out of the microwave and put the headless figure in the water for 3-4 mins.

take the arms off

Take a flat head screwdriver and put it inside the armpit. put the screw driver where the 2 sides of the torso meet and the shoulder joint enter the torso.

Push the screw driver into the shoulder joint torso area and push to the back of the figure to pop the pegs. Do this on both sides






Now for the lower torso Put boxcutter at seam and press down



Put screwdriver in seam and push it as far down as you can. Then turn the screw driver to your right to pop the pegs.






with the waist you have to take a box cutter and put it at the seam and push down.





If it doesnt crack than put the figure in the hot water again for 3 mins. than put a screwdriver down the middle of the seam and turn right. You may have to take the boxcutter and slice the seam of the trunks on the side



Hope this helps out you customizer. Once again thanks to helsinkihellraiser and Apocalypse. I just took their ideas did a little tinkering and just wanted to share it with eveoyone else.