|
|
Post by deluxeking on Dec 20, 2006 15:12:21 GMT -5
I can split the top parts, but how would I go about removing the abs section?
|
|
sleeping forest
POSSIBLE BAD TRADER
those who wander into our forest shall fall into an eternal slumber.
Joined on: Sept 25, 2006 15:42:04 GMT -5
Posts: 1,511
|
Post by sleeping forest on Dec 20, 2006 19:19:09 GMT -5
i tried with da1 hhh and it didn't look good afterwards but it could have just been me.oh yeah i tried with a little screwdriver the same way as the ra part splitting.
|
|
sleeping forest
POSSIBLE BAD TRADER
those who wander into our forest shall fall into an eternal slumber.
Joined on: Sept 25, 2006 15:42:04 GMT -5
Posts: 1,511
|
Post by sleeping forest on Dec 22, 2006 17:45:48 GMT -5
you might not like this way but i just tried opening the bottom part and got it appart. what i did was i got a knife and cut down the center line on the top untill i could see inside of it. after that i stuck a small flat head screwdriver in and pried it opened. hope that helped
|
|
|
|
Post by HR2X on Dec 22, 2006 23:58:33 GMT -5
I haven't tried it yet, but I'm sure it's similar to Marvel Legend torsos. Try and catch it from underneath. Eventually, I'll get some, crack them open and do a tutorial.
|
|
