kliqfan4life
Mid-Carder
"Do not confuse expansion with destruction. The Kliq owns this business!"
Joined on: Feb 21, 2005 6:40:31 GMT -5
Posts: 371
|
Post by kliqfan4life on Jun 11, 2006 13:26:16 GMT -5
Ive been trying to put Ra arms on my ad.13 sets but every time I try and split them open I ruin the figure, Ive tried flat heading the ridges but I crack plastic off, I tried heat gunning them but that warped the figure, any ideas? or does anyone know where I can buy a set?
|
|
|
|
Post by cenasfan on Jun 11, 2006 21:20:05 GMT -5
hey just take a scew driver and right above were the arms are put the screw driver in the space and lift up and then below as the same above then it should loosens up
|
|
|
|
Post by Raoul the Great on Jun 12, 2006 4:00:29 GMT -5
This is actually in the FAQ section of this forum.
Has done me no good though. I can't figure out how to actually break the torso without destroying it. Then I doubt I could put it back together, especially enough to make the figure playable again.
|
|
