|
|
Post by ringofpoison on Jul 5, 2006 5:17:42 GMT -5
Hey, I'm in the UK, so I don't have Sculpey or Super Sculpy, so I was wondering if Milliput would do the same job. I saw it in the same place where I buy my paint, and I was wondering. It says it is Epoxy putty, and I am sure I heard some customizers talk about that.
|
|
|
|
Post by cenasfan on Jul 5, 2006 11:53:18 GMT -5
ya it might work
|
|
|
|
Post by chikara on Jul 5, 2006 12:49:59 GMT -5
LOL at the poster above. What a spammer...
|
|
Deleted
Joined on: Nov 24, 2024 19:52:22 GMT -5
Posts: 0
|
Post by Deleted on Jul 5, 2006 13:22:12 GMT -5
Yes. I use Apoxie Sculpt over here in the States, and it's very similar to Milliput. I wouldn't use Sculpey for anything in the world, it just sucks that bad. Milliput 'gives' a little, so it's really hard to break after it has cured.
Try to remember: when mixing, try to mix equal of both parts. Too much of one color will make it either too pliable or too hard (don't ask whether it's the yellow or blue, I couldn't tell you).
|
|
|
|
Post by ringofpoison on Jul 5, 2006 14:33:04 GMT -5
Yes. I use Apoxie Sculpt over here in the States, and it's very similar to Milliput. I wouldn't use Sculpey for anything in the world, it just sucks that bad. Milliput 'gives' a little, so it's really hard to break after it has cured. Try to remember: when mixing, try to mix equal of both parts. Too much of one color will make it either too pliable or too hard (don't ask whether it's the yellow or blue, I couldn't tell you). Thank you. The first helpful post here. +1 for you, don't know if you care about karma, but meh. |
|
