|
Post by wccwfan4life on May 9, 2011 13:07:56 GMT -5
How hard is it to swap heads on a Mattel elite figure? Im looking to put the DX 2pack HBK head on the DM figure. How can this be done without destroying a figure?
|
|
|
Post by marino13 on May 9, 2011 13:14:10 GMT -5
Very easy, I do it all the time. Soak the head in boiling water for thirty second then pop it right off. After it cool down it will be as good as new.
|
|
Wagdaddy
Main Eventer
Joined on: Feb 11, 2006 20:54:19 GMT -5
Posts: 2,102
|
Post by Wagdaddy on May 9, 2011 13:15:39 GMT -5
run hot water or use a hair dryer on the neck....push a little to loosen it more, then more heat.....then pop it off.
Extremely easy.
|
|
|
Post by wccwfan4life on May 9, 2011 13:17:11 GMT -5
Very easy, I do it all the time. Soak the head in boiling water for thirty second then pop it right off. After it cool down it will be as good as new. Sounds Awesome! I did pulled off the 2packs series1 HBK head awhile back with not hot water and it broke the neck of the figure. Also there was a hook/latch attached to the head, are they not ball jointed? How do i put the head on anohter figure?
|
|
|
Post by marino13 on May 9, 2011 13:25:06 GMT -5
Very easy, I do it all the time. Soak the head in boiling water for thirty second then pop it right off. After it cool down it will be as good as new. Sounds Awesome! I did pulled off the 2packs series1 HBK head awhile back with not hot water and it broke the neck of the figure. Also there was a hook/latch attached to the head, are they not ball jointed? How do i put the head on anohter figure? I broke my first Mattel head swap too. But once I started with the hot water I haven't had any break on me. Once the neck peg is broke I'm pretty sure the body is no good without glue. As for the head you could still soak it, and use a pair of needle nose pliers to pull the peg out.
|
|
hierosis
Main Eventer
Joined on: Mar 13, 2011 14:06:36 GMT -5
Posts: 1,083
|
Post by hierosis on May 9, 2011 13:47:51 GMT -5
|
|
|
Post by jfinnomore on May 9, 2011 16:34:19 GMT -5
Very easy, I do it all the time. Soak the head in boiling water for thirty second then pop it right off. After it cool down it will be as good as new. Sounds Awesome! I did pulled off the 2packs series1 HBK head awhile back with not hot water and it broke the neck of the figure. Also there was a hook/latch attached to the head, are they not ball jointed? How do i put the head on anohter figure? yeah just make sure the water is hot enough and if it doesn't pop right off give it a little more time in the water. the pegs are hook and peg so you just have to repeat the process to put them on another figure. heat the head, get it soft, and it pops right back on the peg.
|
|