BROSKI
Superstar
WWWYKI!!!!
Joined on: Feb 16, 2010 22:26:03 GMT -5
Posts: 593
|
Post by BROSKI on Aug 25, 2011 3:42:51 GMT -5
Ehh Hemm.... My bad..... "The" Brian Kendrick. I was going to make an Elite Kendrick figure but the only plain black kickpads are in basic, How do i get basic kickpads on elite figures? A pic would be great if you've done it before.
|
|
|
Post by ¡Twist Of Cinnamon! on Aug 25, 2011 3:55:09 GMT -5
Heat the boots up with either hot water or a hair dryer for about 30 or so seconds, pull off the boots which should make the knee pads easily slide off. Swap em over then put the boots back on.
|
|
BROSKI
Superstar
WWWYKI!!!!
Joined on: Feb 16, 2010 22:26:03 GMT -5
Posts: 593
|
Post by BROSKI on Aug 25, 2011 4:09:06 GMT -5
Heat the boots up with either hot water or a hair dryer for about 30 or so seconds, pull off the boots which should make the knee pads easily slide off. Swap em over then put the boots back on. Could I put the basic knee on the elite?
|
|
|
Post by ¡Twist Of Cinnamon! on Aug 25, 2011 4:11:26 GMT -5
Should be able to but you'll lose the double knee joint and the figure will be shorter and out of scale.
|
|
BROSKI
Superstar
WWWYKI!!!!
Joined on: Feb 16, 2010 22:26:03 GMT -5
Posts: 593
|
Post by BROSKI on Aug 25, 2011 15:09:11 GMT -5
Should be able to but you'll lose the double knee joint and the figure will be shorter and out of scale. It's a Drew Mcityre elite figure and he's kinda tall, Brian Kendrick is short so that should be fine right?
|
|