|
Post by RybackV1 on Nov 4, 2012 0:44:55 GMT -5
I hate to sound dumb. But I just recently bought a Paul Heyman on Ebay because I want to put the head on my BAF Cole body. The question I have is, how in the hell do you get a Jakks RA head on a Mattel Body? ! Help plz??
|
|
|
Post by joesgonnakillyou on Nov 4, 2012 10:33:04 GMT -5
Soak the head in very hot water for about a minute or two then pull the head off. Place head on Cole body before it cools down completely
|
|
|
Post by RybackV1 on Nov 4, 2012 10:34:56 GMT -5
Well that is how I go about doing Mattel headswaps. But with the Jakks RA head. The Pin in inside of the head, rather than Mattel where the Pin sticks out of the Torso.
|
|
|
Post by Prophet of Ash on Nov 4, 2012 14:59:06 GMT -5
pull the pin out of the head
|
|
ebenj
Mid-Carder
Never Forgotten
Joined on: Jul 11, 2011 21:25:45 GMT -5
Posts: 295
|
Post by ebenj on Nov 4, 2012 14:59:19 GMT -5
It should be the same as Mattel's... They are usually all the ball joint inside the head that should just pop out when heated enough...
|
|
|
Post by "The Gothic Superstar" Ronin on Nov 5, 2012 12:35:52 GMT -5
most of the time the pin stays in the body when Im working with RAs n DAs, sometimes if I dont heat it enough it comes out but luckily the neck doesnt crack
|
|
brianregan09
Superstar
Subscribe to my youtube :)
Joined on: Nov 17, 2010 17:05:22 GMT -5
Posts: 881
|
Post by brianregan09 on Nov 5, 2012 13:45:00 GMT -5
What do you usually use to pull the pin out have had some awful trouble with some
|
|
kev bamber
Superstar
WF 10 Year Member
Joined on: Aug 22, 2002 8:07:45 GMT -5
Posts: 665
|
Post by kev bamber on Nov 5, 2012 14:28:09 GMT -5
needle nose pliers
|
|