MWFD
Main Eventer
Joined on: Sept 19, 2012 11:48:30 GMT -5
Posts: 1,479
|
Post by MWFD on Feb 13, 2018 13:31:11 GMT -5
So I just picked up Walmart Flashback Elite Yokozuna last week and noticed that the head sits way too high on the neck. He looks like a giraffe compared to my other 2 Yokos and I was wondering if there is any easy way to fix this? I'm not much of a customizer so I was wondering if there were any simple solutions? If not, I may look to return/exchange assuming A)I'm able to find another one and B)this isn't a widespread issue. Anyone else have this problem with their Yoko?
|
|
|
Post by Mongo Bears on Feb 13, 2018 13:46:00 GMT -5
I wanna see..
|
|
|
Post by PJ on Feb 13, 2018 14:11:37 GMT -5
I passed on this one, because I have the other two. But I haven’t heard of this before with this new figure so I don’t think it’s a widespread issue. Is the head all the way on? Maybe it wasn’t pushed down all the way? Try heating it with a hair dryer for a minute or two and see if you can push it down more.
|
|
bharrisfan
Main Eventer
Joined on: Oct 10, 2010 1:00:19 GMT -5
Posts: 2,041
|
Post by bharrisfan on Feb 13, 2018 17:03:14 GMT -5
^ ya mines the same at the other 2 yokos i dont understand how mdt could design an all new parts figure for the first yoko and make him like 8 inches too tall
|
|
ero
Superstar
Joined on: Oct 17, 2011 17:10:01 GMT -5
Posts: 751
|
Post by ero on Feb 13, 2018 18:19:24 GMT -5
So I just picked up Walmart Flashback Elite Yokozuna last week and noticed that the head sits way too high on the neck. He looks like a giraffe compared to my other 2 Yokos and I was wondering if there is any easy way to fix this? I'm not much of a customizer so I was wondering if there were any simple solutions? If not, I may look to return/exchange assuming A)I'm able to find another one and B)this isn't a widespread issue. Anyone else have this problem with their Yoko? I usually take a drill bit just a bit smaller than the peg hole and hand twist it, gradually removing the bits of plastic until it fits. This works best in figures that are intended for head swaps (Marvel Legends, MOTUC, etc) and can be more cumbersome on figures that require heat.
|
|