|
|
Post by BDF Wrestling Action! Owner on Apr 6, 2008 20:41:38 GMT -5
 Okay as soon as i took it out the package i noticed his left arm would not come down. Then i looked at the ball joint and it seemed that the plastic was melted on where the little line that lets the figure arms come down to their waist. Can anyone find a solution for me? Thanks |
|
★Mr. Korn★
Main Eventer
Joined on: Sept 2, 2006 23:17:48 GMT -5
Posts: 1,735
|
Post by ★Mr. Korn★ on Apr 6, 2008 21:05:25 GMT -5
If you have an old RA or something, you could replace the ball joint.
First, open the body by, boiling water and placing it in.
Then pull off the head, then get a flathead screwdriver and place under shoulder. Push down until the seam snaps, do this for both sides. Then do the same for under the arm. Then it shall open, then do the same thing and get the ball joint off of the other figure and then swap it. Then all you need to do it glue the figure back together. With most types of glu. I use testors plastic glue.
Smite?
|
|
