|
|
Post by nightwing on Nov 22, 2006 13:25:30 GMT -5
I have read before that you can boil a figure to loosen up a joint but are there any other ways?. I recieved a petey williams and another rhino both have stiff joints. I have gone through 3 rhinos with stuck arms that will not move. The other 2 rhinos broke when I slowly tried to move their arms down. I have 12 other TNA figures with no joints problems and these are the only two figures I've had like this. Any help would be appreciated.
|
|
T. Selanne
POSSIBLE BAD TRADER
2007 Stanley Cup Champion
Joined on: May 3, 2002 11:21:49 GMT -5
Posts: 6,622
|
Post by T. Selanne on Nov 22, 2006 20:33:00 GMT -5
I put any loose jointed figures of mine on the fireplace when I have it on. They get soft enough to maneuver them around enough. If you don't have a fireplace, use a hairdryer maybe...
|
|
Deleted
Joined on: Nov 26, 2024 2:25:46 GMT -5
Posts: 0
|
Post by Deleted on Nov 23, 2006 1:57:10 GMT -5
The water doesn’t need to be at a boil. I was and still am a little weary of putting an action figure into boiling water so I tried with hot tap water and it worked ok. I've never tried a blow dryer but I hear it works ok too.
|
|
|
|
Post by fmw on Nov 25, 2006 11:56:34 GMT -5
Boiling water is a good method. If your worried about something happening..just watch the fig.
|
|
Nitro
Main Eventer
Joined on: Sept 29, 2006 18:50:40 GMT -5
Posts: 3,839
|
Post by Nitro on Nov 25, 2006 19:34:25 GMT -5
I only worry about putting the figures head or bodyparts with logos into boiling water because i fear the paint on logos or face detail will melt away....
|
|
