knee and lowerleg problem

figuregoon
Guest

knee and lowerleg problem Dec 5, 2006 17:02:39 GMT -5

Quote

Post by figuregoon on Dec 5, 2006 17:02:39 GMT -5

Hi guys I have a prob that maybe you can help with.

I made a custom raven using jamie noble body with the lower legs swapped for short black boots,

however I can't get the lower legs to fit on the knee pins correctly. the shorts get in the way and i tried all kinds of ideas.
the fig looks awesome but with the legs not going on properly the legs look stupid,

any help would be greatly appreciated

Last Edit: Dec 5, 2006 17:08:34 GMT -5 by figuregoon

wwe4ever Guest	knee and lowerleg problem Dec 5, 2006 18:17:21 GMT -5 Quote Select Post Deselect Post Link to Post Back to Top Post by wwe4ever on Dec 5, 2006 18:17:21 GMT -5 Try using a screwdriver to push the peg in from the inside. it works for me but I hae never done it with that pants mould. Like you said it would be a lot harder to try and put the peg in from the outside because of the way the mould is.

Bartman WF Hall of Famer *WF 10 Year Member* Joined on: Aug 6, 2003 21:47:52 GMT -5 Posts: 17,298	knee and lowerleg problem Dec 5, 2006 19:25:40 GMT -5 Quote Select Post Deselect Post Link to Post Back to Top Post by Bartman on Dec 5, 2006 19:25:40 GMT -5 Boil the legs first, and then proceed to push the pin through with a screwdriver. It makes it loads easier.

BIGticket5 Main Eventer add me: www.myspace/rostafer_23 Joined on: Jan 26, 2002 20:01:11 GMT -5 Posts: 1,745	knee and lowerleg problem Dec 6, 2006 4:18:50 GMT -5 Quote Select Post Deselect Post Link to Post Back to Top Post by BIGticket5 on Dec 6, 2006 4:18:50 GMT -5 you don't need to boil...just run under really hot tap water. others use a hairdryer.

Post by figuregoon on Dec 5, 2006 17:02:39 GMT -5

Post by wwe4ever on Dec 5, 2006 18:17:21 GMT -5

Post by Bartman on Dec 5, 2006 19:25:40 GMT -5

Post by BIGticket5 on Dec 6, 2006 4:18:50 GMT -5