|
Post by James St. James on Jan 15, 2007 2:25:30 GMT -5
I'm currently hunting down all the ttl divas to put them on the ra body, and I was wondering if they will fit?
I know ra divas hall ball joints, but what about.........
HOP Tori ROTR Ivory Chyna
If they are not ball joints is there any way to MAKE them fit?
Thanks
|
|
|
Post by knightpryde on Jan 15, 2007 16:43:01 GMT -5
they TTL heads are Ball joins. the ball joint faces up from the body, not down from the head like the RA's do.
you can Rip the RA ball heads out but it really hard, and I have never been able to do it succesfully. I usually end breaking the figure's face in half.
|
|
|
Post by thematthardyjr on Jan 15, 2007 23:23:49 GMT -5
Boil the TTL diva in water and pop the head off. Then take the head off a RA diva and boil that in water also, then use a tool to take the ball joint out of the RA diva's head and stick it into the TTL diva's head. You can just stick the TTL head on the RA body then.
|
|
|
Post by cureforthesickness on Jan 17, 2007 8:33:23 GMT -5
Boil the TTL diva in water and pop the head off. Then take the head off a RA diva and boil that in water also, then use a tool to take the ball joint out of the RA diva's head and stick it into the TTL diva's head. You can just stick the TTL head on the RA body then. boiling divas is not a good idea, because all divas have rubber hair. Rubber parts do not do well boiled. You're also failing to acknowledge the fact that the TTL peg hole in TTL heads is not as deep as the RA peg hole, therefore, the heads stick up really awkwardly. I'm sure if you search around, you can find a badly put together RA Justin Credible or something with this problem. Your best bet on diva figures or any figure with plastic heads to remove them is to stick a flat head screwdriver up underneath the chin and force the head upwards. It should pop off of the TTL peg quite easily. From there, find a drill with a small bit. Stick the drill head into the TTL diva body and etch away some plastic. This will make the RA ball joint peg fit into the head well. Now you're going to need the peg for the figure. Find the diva head you're willing to sacrifice for the peg and REMOVE THE HAIR!! the hair piece should peel off pretty easily. Once the hair is off, put the head into boiling water for about 10-15 seconds. Pull the head out and with a pair of needle nose plyers, pull the peg out of the head. with the plastic weakened from boiling, it should come out rather easily. While the peg plastic is still weak, shove it into the TTL diva head. Really, converting TTL divas to RA isn't worth it for the most part. TTL figures are of higher quality than RA figures, even customs, for the most parts. You named off the HOP Tori as one of your examples. That is one of the best TTL figures around and is better than any RA diva that has been made. TTL divas often have unique parts that work perfectly for the individual woman.
|
|