Deleted
Joined on: May 15, 2024 13:13:28 GMT -5
Posts: 0
|
Post by Deleted on Jul 26, 2013 7:29:15 GMT -5
I just picked up a lot of Mattel figures but they are missing lots of accessories anybody got these and and will part with them I would appreciate it
I'm new to this so I don't even know if you can buy stuff on this board. Ill wait for someone to tell me before I list the accessories I need
I do need to clean up this figures as they have been played with. Any good way or special way to do that?
Thanks in advance
Also any difference in the Best of 2010 Elite Mysterio, Orton & Undertaker compared to their earlier 2010 Elite figures? (As far as accessories really is what I need to know)
|
|
mrtheiphonekid
Mid-Carder
Joined on: May 23, 2013 6:36:11 GMT -5
Posts: 403 
|
Post by mrtheiphonekid on Jul 26, 2013 7:39:02 GMT -5
Magic Eraser. Or Goo Gone on a cotton swab.
|
|
Deleted
Joined on: May 15, 2024 13:13:28 GMT -5
Posts: 0
|
Post by Deleted on Jul 26, 2013 7:46:31 GMT -5
Thank you
|
|
|
|
Post by blu3blazer on Jul 26, 2013 10:11:59 GMT -5
Be careful with Magic Eraser! I've accidentally smudged logos on figures using them.
I use large plastic food containers and fill them up with hot water, using a little bit of dish soap. Then I soak the figures for a few minutes and most of the marks will come off with a washcloth or sponge.
|
|
|
|
Post by PJ on Jul 26, 2013 11:09:52 GMT -5
Warm soapy water and small soft bristle brush works well.
|
|
Deleted
Joined on: May 15, 2024 13:13:28 GMT -5
Posts: 0
|
Post by Deleted on Jul 26, 2013 12:23:50 GMT -5
Goof off on a cotton swab goof off is about 5.99 for a small can wich goes a long way
|
|
MELO
Main Eventer
Member formerly known as melomano
Joined on: Jul 25, 2012 19:00:46 GMT -5
Posts: 1,162
|
Post by MELO on Jul 26, 2013 16:39:52 GMT -5
Nice, I actually have a similar question. Since you guys answered about cleaning up the figures from marks and smudges, I'd like to know about any tips for pant chips and scratches? Like say an eyebrow is chipped, what paint to use and how to apply it so as to maintain the factory made detail. Thanks!
(and to the OP, sorry to add to your thread but I figured my questions is similar to yours or applies to it and I didn't want to open a new thread for it.)
|
|
Deleted
Joined on: May 15, 2024 13:13:28 GMT -5
Posts: 0
|
Post by Deleted on Jul 26, 2013 17:21:18 GMT -5
Goof Off. Just make sure use use a tiny amount and have a steady hand.
|
|
