|
|
Post by takerrules on Aug 1, 2006 19:43:55 GMT -5
How yould you hollow out a ttl head? I made a McMahon custom but he has the Ax proto giraffe neck syndrome going on, I either wanted to cut a few millimetres of the neck part of the torso or hollow out the TTL head whichever's easier, and advice on how to do it? Thanks, to wwe4ever for an answer to the question that was in this thread prior to this one. lol.
|
|
|
|
Post by wwe4ever on Aug 1, 2006 20:08:09 GMT -5
to get the torso off a fig get a flat head screwdriver. then put it in the crack beside the shoulder. push back for leverage. do the same thing to the other side of the shoulder. then move to the opposite side and repeat the same thing. then to split the top part get 2 flat head screwdrivers and and push them down and pull them back in opposite directions. if the torso doesn't loosen up boil it first then split it.
to remove the hands boil the arm of the fig for about 10 minutes. then get pliers and pull the hand out. that should work.
to remove a ttl head you have to boil the fig. then carefully hollow it off. then maybe put an ra fig's peg in the ttl head. i have never done it before so i dont know about the ttl head.
when your putting a torso back on just use supeglue to make it stick back together without any problems. I hope I helped.
|
|
|
|
Post by andih on Aug 2, 2006 9:15:35 GMT -5
Just had a go at hollowing out my first TTL head. I just used a blade and chisselled away at the inside of the head until it was mostly hollow. Then i glued an RA peg to the head and just popped it into the figure. Sorry i can't be as descriptive on how best to go about it though.
|
|
Deleted
Joined on: Nov 25, 2024 5:58:42 GMT -5
Posts: 0
|
Post by Deleted on Aug 2, 2006 10:21:49 GMT -5
|
|
