|
|
Post by King of Bling Bling on Aug 8, 2006 23:12:59 GMT -5
switch RA2 Dreamer's boots with ONS Dreamer's boots. i tried pushing the peg, but it didnt work. also tried the same method as switching lower legs, didnt work either. any ideas?
|
|
|
|
Post by cooga99 on Aug 9, 2006 4:17:21 GMT -5
either boil the figure for a couple of mins or let it sit under really hot water for bout 5-10mins. (Makes figure soft) Take a tiny flat head screw driver and slide it between the knee joins and pull one side of the knee away. (like this)  At this point you should be able to wiggle the bottom of the leg and the peg lose. When youve done that line the holes up and push the peg in. It might be difficult at first but just use a small pair of pliars to squeeze it in |
|
Deleted
Joined on: Nov 25, 2024 9:56:25 GMT -5
Posts: 0
|
Post by Deleted on Aug 9, 2006 5:44:54 GMT -5
The method I use:
Get a hair dryer and on high heat, heat the knee joint. When it has become rubbery, take your screwdriver and push the pin out.
To get it back in, you might have to heat it up again. Place the limb into position and push the pin back in.
|
|
custom kenny
Superstar
"where's JSH???"
Joined on: Mar 31, 2006 17:06:49 GMT -5
Posts: 690
|
Post by custom kenny on Aug 9, 2006 6:45:45 GMT -5
i think he means a foot swop as switching those dreamer lower legs wouldnt really work
|
|
|
|
Post by King of Bling Bling on Aug 9, 2006 11:37:27 GMT -5
i think he means a foot swop as switching those dreamer lower legs wouldnt really work ya because they are different pants molds and there is a white pattern on ra2 dreamer, i just need to switch the feet. |
|
