EventOmega
Main Eventer
WF 15+ Year Member, Can You Beleive this guy?
Eventomega
Joined on: Mar 22, 2005 10:29:42 GMT -5
Posts: 1,821
|
Post by EventOmega on Sept 6, 2006 5:21:01 GMT -5
ive got a DA2 edge that has a very loose waist, how can i make it abit tighter?
i also want to take my DA2 undertakers head and swap it with a ppv7 undertaker head, hoiw would i go about doing that? and do you think ppv7 undertakers head will be big enougth?
thanks, EventOmega.
|
|
custom kenny
Superstar
"where's JSH???"
Joined on: Mar 31, 2006 17:06:49 GMT -5
Posts: 690
|
Post by custom kenny on Sept 6, 2006 9:52:39 GMT -5
the head will work. just heat it up with a hair dryer or boiling water and just grab it and pull it off.
for the waist maby just putting a tiny bit of glue between the waist and legs. just enough to tighten it up with friction but not to glue it completly together
|
|
|
|
Post by ianarchy on Sept 7, 2006 2:55:09 GMT -5
To tighten up joints, one thing I do is to take a piece of elastic jewelry thread (You can buy it at any craft store or probably any hobby section like at a Wal-Mart or K-Mart). Just wrap it around the loose joint a couple of times, tie a double knot, stretch out the elastic thread and cut the ends and it should snap back into place.
|
|
Nash
Main Eventer
Joined on: Sept 9, 2006 10:04:30 GMT -5
Posts: 2,699
|
Post by Nash on Sept 9, 2006 15:21:15 GMT -5
For loose joijnts, sometimes it works to pur a little super glue in the designated loose area and keep moving that joint so it doesn't permanently stick.
|
|
