Wago
Main Eventer
Prepare To Get Wagowned.
Joined on: Mar 29, 2006 9:11:27 GMT -5
Posts: 1,495
|
Post by Wago on Sept 6, 2006 13:04:12 GMT -5
Hello im making a first time custom and Ive come upon a problem and Im wondering if you could help me?
Im attatching a head from a Jeff Hardy in the old sets (The ones with the magazine covers if any of you remember) anyway I can glue it on so I need the joint from inside the RA figures ahead to come out so I can use it for my Jeff Hardy, does any one no how.
(Sorry im kinda new)
|
|
hollywoodryan
Main Eventer
nWo 4-Life
Joined on: Feb 15, 2004 19:10:15 GMT -5
Posts: 2,010
|
Post by hollywoodryan on Sept 6, 2006 14:09:17 GMT -5
well, there is a thread on this somewhere, but what you have to do to make a TTL head fit on an RA body is:
Hollow out the TTL head so that an RA ball joint can fit into it and so the head fits properly on the RA body. If you dont hollow it out a bit it will look bad because of the long neck...To get an RA ball joint out of another head, just pop off a head and heat it up in boiling water for about 10 seconds.. then just get some needle nose pliars and pull it out and pop it into the other head and shove that head onto the RA body... its actually realy easy..
|
|
|
|
Post by outcode on Sept 6, 2006 14:49:32 GMT -5
Customs Support Center.  |
|
Wago
Main Eventer
Prepare To Get Wagowned.
Joined on: Mar 29, 2006 9:11:27 GMT -5
Posts: 1,495
|
Post by Wago on Sept 6, 2006 15:52:44 GMT -5
Thanks, Soz about putting it in the wrong bit, Plus 1 Karma
|
|
