ECWFigureFed
Mid-Carder
Joined on: Aug 22, 2016 8:58:04 GMT -5
Posts: 84
|
Post by ECWFigureFed on Jun 27, 2017 8:13:38 GMT -5
Recently it came to my attention that when using newer ring ropes from ringside on my Mattel elite scale ring it becomes uneven due to the tension of the ropes. One side of the ring becomes higher than another. Has any one else come across this? If so what if anything are you able to do to fix this issue?
|
|
|
Post by Stuart? on Jun 27, 2017 8:38:15 GMT -5
Why is this being posted on the main Pic Fed board? Going to move it to the Discussion Board until I figure out where this should actually be posted.
|
|
ECWFigureFed
Mid-Carder
Joined on: Aug 22, 2016 8:58:04 GMT -5
Posts: 84
|
Post by ECWFigureFed on Jun 27, 2017 8:53:18 GMT -5
Why is this being posted on the main Pic Fed board? Going to move it to the Discussion Board until I figure out where this should actually be posted. I only ask because its off set to the point where it is noticeable in photograph. My set up is primarily used to shoot for stop motion and action poses
|
|
|
Post by Stuart? on Jun 27, 2017 9:25:44 GMT -5
Why is this being posted on the main Pic Fed board? Going to move it to the Discussion Board until I figure out where this should actually be posted. I only ask because its off set to the point where it is noticeable in photograph. My set up is primarily used to shoot for stop motion and action poses This is the picture federation board, the poses/action shots board is probably better suited or even the Mattel Board. If you're doing stop motions, I'm pretty sure it has nothing to do with Pic Feds.
|
|
|
Post by hCo.Bro™ [brandon_lee] on Jun 30, 2017 16:43:52 GMT -5
I'd almost say the main Mattel board, there will be more non fedder collectors there. I don't have this ring myself but I'm sure the ropes will loosen over time. I'd almost undo a corner when your not using it to prevent any warping that could occur. Might try to take them off and stretch them a bit.. Seen your stuff on instagram and like your shots! Hope you share it with the guys here.
|
|