|
|
Post by mrbotch on Apr 30, 2007 21:15:02 GMT -5
Hey,
I Want to make a Custom Figure and put it in a CS Box.HOwever i was wondering for CS Boxes is there a certain way i remove the fig from the package so i don't destroy the Box
~thanks~
|
|
|
|
Post by onionmaster on May 1, 2007 14:28:46 GMT -5
This goes in customs support centre, but as I'm feeling nice I'll answer your question. You should use a butter knife to slide carefully along the place where the plastic joins up to the cardboard, peel it away carefully, do the same for the next bit of plastic and glue it together when your figure's inside.
|
|
|
|
Post by mrbotch on May 2, 2007 22:26:50 GMT -5
This goes in customs support centre, but as I'm feeling nice I'll answer your question. You should use a butter knife to slide carefully along the place where the plastic joins up to the cardboard, peel it away carefully, do the same for the next bit of plastic and glue it together when your figure's inside. OK Thanks So Much For Helping Sorry bout Puting it in the Wrong Board +1 for you:) |
|
